SCM series 6015 ultrafine mill ---thin grinding mill
Brief introduction
On the basis of more than 15 years’ production experience of our company, we absorb the fine mill's technology advantages from the same field abroad and domestic, organizing fine mill's elite powder processing experts to investigate, research, try again and again; finally, we develop this high-efficiency and low-cost Super Thin Grinding Mill (Ultrafine Mill,fine mill).
scm series 6015 ultrafine mill ---thin grinding mill
Product Application
SCM Series Super Thin Grinding Mill (Ultrafine Mill,fine mill) is mainly applied to the powder processing of mineral products in industries of metallurgy, construction, chemistry, Fertilizer and mining etc. The Super Thin Grinding Mill (Ultrafine Mill)can produce powder from non-flammable and non-explosive mineral materials with Mohs hardness below 9 and humidity below 8%, such as barite, limestone, quartz, calcite, granite, porcelain clay, basalt, gypsum etc.
scm series 6015 ultrafine mill ---thin grinding mill
specification
| Model |
Number of Roller (pcs) |
Diameter of Roller(mm) |
Number of Rings (pcs) |
Rev of Main Fram (r/min) |
Max. Feed Size (mm) |
Finished Size (mesh) |
Capacity (kg/h) |
Overall Dimension (m) |
| SCM6015 |
15 |
φ600 |
1 |
235 |
<=10 |
325-2500 |
325-2500 |
10*2.3*5.5 |
| SCM8021 |
21 |
φ800 |
1 |
235 |
<=10 |
325-2500 |
325-2500 |
13*3*5.8 |
| SCM10027 |
27 |
φ1000 |
1 |
173 |
<=20 |
325-2500 |
325-2500 |
18*4*8.6 |
scm series 6015 ultrafine mill ---thin grinding mill
Features & benefits
1. High efficiency : Under the same condition of finished particle size and power of motor, the output of the ultrafine mills ---thin mill 40% higher
than traditional airflow
grinding mill and whisk grinding mill.
2. Environmental protection : Pollution and noise are lightened by using deduster and muffler so as to reach the requirement of national
environmental protection under the usage of Shibang ultrafine mill ---thin grinding mill.
3. High safety : No axle tree or bolt is used in the ultrafine chamber, so there will be no worn out problem of bearing and sealing parts,
and also no loose of bolts during the run time of Shibang ultrafine mill ---thin mill.
4. Finished size of the powder which is produced by Shibang ultrafine mill ---thin mill can reach to d97≤5μm.
5. High using rate of spare parts of Shibang ultrafine mill ---thin grinding mill.
scm series 6015 ultrafine mill ---thin grinding mill
working principle
The main motor of Shibang ultrafine mill ---thin mill drives main axle and every layer rotating by the power of reducer. Dial drives numbers of
rollers rolling and rotating in the ring by pintles. Big materials are crushed into small particles by hammer crusher. Then they are sent to store
house by elevator. Vibrating feeder send the materials evenly to the middle of the upper dial. Under the function of the eccentricity, the
materials fall into the ring of the ultrafine mill ---thin mill to be pressed, crushed and milled into pieces by rollers. After the first crush, materials fall into the second and third
layer. The pumping of the high-pressure centrifugal blower put the outside air into thefine mill machine. The coarse powder will be brought into the
classifier.
