Fangyuan Machinery to teach you how to use the mill safely
(1) The crusher should be fixed on a cement base. If the working place is often changed, the crusher and the motor should be installed on the frame made of Angle steel.
(2) After the installation of the crusher, check the fastening of the components, and check whether the tightness of the transmission belt is appropriate, and whether the motor shaft and the crusher shaft are parallel.
(3) Before the mill starts, rotate the rotor by hand to check whether the operation is flexible and normal, whether there is collision in the housing, whether the rotation direction of the rotor is correct, whether the motor and the mill are well lubricated.
(4) Do not replace the pulley casually to prevent the speed from being too high or too low.
(5) The crusher should be idled for 2-3 minutes after starting, and then feed after no abnormal work.
(6) The feeding should be uniform, if there is noise, bearing and body temperature is too high or spray out, it should be stopped immediately for inspection and troubleshooting.
(7) Carefully check the material to avoid metal, stone and other hard objects into the crushing chamber to cause accidents.
(8) When feeding, the staff should stand on the side of the crusher to prevent the debris from bouncing out of the face. Do not grip the long stalk too tightly to prevent the hand from being brought in.
(9) Stop feeding before stopping, wait for the material in the machine to be cleared, and then cut off the power to stop. Cleaning and maintenance should be carried out after shutdown.
(10) After 300 hours of mill operation, the bearing must be cleaned and the oil replaced; When installing oil, it is best to fill 1/3 of the bearing seat gap, and the maximum should not exceed 1/2. The belt should be removed when the machine is shut down for a long time.
To learn more about our Fangyuan products, please click this link ：https://www.fine-mill.com.
