Equipment blockage is a common problem and failure in the use of multi-functional mill, there may be problems in the design of equipment, but more often it is caused by improper operation of the user, how to solve the problem after improper operation caused by equipment blockage? How to standardize the operation process?
1, feed speed is too fast. Too fast feeding speed will lead to an increase in the operating load of the equipment, which will cause equipment clogging. In the feeding process, we should always pay attention to the deflection Angle of the ammeter pointer, if it exceeds the rated current, it indicates that the motor is overloaded, and long-term overload will burn the motor. In this case, the feed amount should be reasonably controlled or the feeder should be increased to control the feed amount.
2, the material is not smooth. The discharge pipe is not smooth or the improper conveying equipment will cause the blockage of the equipment, should first clear the feed port, change the mismatched conveying equipment, adjust the feed amount, so that the equipment can operate normally.
3, the material water content is too high. The high water content of the crushed material will cause the blockage of the multifunctional grinder, and the water content of the crushed material should be less than 14%, which can improve the production efficiency, but also make the crusher not blocked, and enhance the reliability of the mill.
The above lists the causes of equipment congestion, as well as specific solutions, but often several factors occur at the same time, various factors will also have a certain correlation, the solution is to do a comprehensive analysis, and then targeted measures for specific problems.
To learn more about our Fangyuan products, please click this link ：https://www.fine-mill.com.
