Comparing with other crushing equipment, the material advantage of Chinese medicine crusher is obvious. After the material is processed by the Chinese medicine crusher, the particle size of the material is uniform and fine, which can make the material better dispersed and improve the utilization rate. However, it should be noted that there will be some failures during the operation of the machine, such as; Too much material causes clogging. If the Chinese medicine crusher is blocked, the running speed on the other side is unbalanced, the crushing material efficiency is low, and the crushing quality of the material is difficult to ensure. On the other hand, if the device does not find the cause of the fault and take measures to resolve it, the device will inevitably fail to work properly or the user's operation security will be affected. So, how should we solve the problem of Chinese medicine crusher blockage?
The more direct reason may be that the discharge pipe is not smooth or the feed is too fast, making the equipment blocked. Generally speaking, the user can check the discharge pipe first, if it is blocked, it should be handled and dredged in time. In addition, the user should evenly put the material, not too fast or too much. At this time, the feed door can also be reduced or closed, and the feed amount can be controlled by changing the feeding method and using the feeder to avoid the equipment clog caused by uneven manual operation.
Hammer fracture, aging, screen hole closure, tattered, etc., will also be blocked. Because the hammer and screen are important components of the ultrafine grinder. Among them, the problem of the screen not only easily causes the material to be unevenly discharged, but also causes the equipment to be blocked by the accumulation of a large amount of material in a short time, and also affects the material crushing effect. Therefore, the user should regularly check and replace the existing problems of the hammer, screen, to maintain the good working condition of the crusher. In addition, the material humidity is too large may also lead to the blockage of the ultrafine mill. We know that the ultrafine grinder is the use of air separation, heavy grinding, shearing in the form of dry material ultrafine grinding machinery. If the humidity is too high, put into the equipment, because the temperature will rise during operation, the heat-sensitive material is very easy to stick, and then the crusher is blocked.
To this end, before crushing, the user needs to take some measures to ensure the dryness of the material, the water content of the crushed material should be less than 14%, which can improve production efficiency, but also make the crusher not blocked, enhance the stability and reliability of the work, and ensure the quality of the material crushing. These are the common causes of congestion, and the corresponding solutions. Machine failure is very common, in addition to the reasons mentioned above, improper user operation, improper maintenance, poor quality of equipment, etc., may lead to blockage. In the face of such situations, users should check in time, find out the cause, and take appropriate measures to ensure the normal operation of the equipment.
To learn more about our Fangyuan products, please click this link ：https://www.fine-mill.com.
Our WhatsApp:+86 18921278133
