Mar 14, 2024 Leave a message

What Are The Parts Of The Mill That Need To Be Maintained?

Due to the widespread use of multi-functional shredders in all walks of life, the research and development of multi-functional shredders at home and abroad are attached great importance.

At present, there is still a lot of potential in the market of multi-functional shredders, but there are not many fist products with real vitality, and it still needs to be invented by the majority of scientific researchers and shredder manufacturers to develop a multi-functional shredder that can solve practical problems and has high efficiency to fill the technical gaps in China and even the world.

Multifunctional mill is suitable for pharmaceutical, chemical, metallurgical, food and other industries. It can process hard and difficult to crush materials, including plastics, Chinese herbs, rubber, etc., and can also be used as a supporting equipment for the previous process of ultrafine mill processing, which can not be used for the crushing of metal items, not suitable for the crushing of large materials, crushing water content is too high, oil content is too high, because the water or oil is produced after crushing, forming a paste. It will block the screen, affect the discharge, cause the discharge is not smooth, and even stuck, stuffy and other phenomena.

Multifunctional shredders often need maintenance and replacement parts:

 

8

 

First, screen repair and replacement. The screen is made of thin steel or iron perforated. When the screen is worn or broken down by foreign matter, if the damage area is not large, it can be repaired by riveting or tin welding; If large area damage, should be replaced with a new screen. When installing the screen, the side of the screen hole with burrs should face in, the light side should face out, and the screen sheet and screen frame should be tightly fitted. When the ring screen is installed, the stubble of the lap inner layer should follow the rotation direction to prevent the material from getting stuck at the lap.

2. Lubrication and replacement of bearings. The bearings should be cleaned after every 300 hours of work. If the bearing is lubricated by oil, it is appropriate to fill the bearing seat gap by 1/3 when adding new oil, at most not more than 1/2, and only need to tighten the normally covered oil cup lid a little before operation. When the bearings of the multi-functional grinder are seriously worn or damaged, they should be replaced in time, and pay attention to strengthening lubrication; The use of tapered roller bearings, should pay attention to check the bearing axial spacing, so that it is maintained at 0.2-0.4 mm, if there is discomfort, can be adjusted by increasing or decreasing the paper pad at the bearing cover.

To learn more about our Fangyuan products, please click this link :https://www.fine-mill.com/products.

Send Inquiry

whatsapp

Phone

VK

Inquiry