1. The vibration crusher generally uses a motor to directly connect the crushing device, which is simple and easy to maintain. However, if the two cannot be connected well during the assembly process, it will cause the overall vibration of the crusher.
(1) The motor rotor is not concentric with the crusher rotor. The position of the motor can be moved left or right, or a pad can be added under the motor foot to adjust the concentricity of the two rotors.
(2) The pulverizer rotor is not concentric. The reason is that the two supporting surfaces of the palm rotor shaft are not in the same plane. Copper sheets can be placed on the bottom surface of the support bearing seat, or adjustable wedges can be added at the bottom of the bearing to ensure that the two shaft heads are concentric.
(3) The vibration in the crushing chamber is relatively high. The reason is that the connection between the coupling and the rotor is not concentric or the quality of the flat hammer inside the rotor is uneven. Corresponding methods can be adopted to adjust the connection between the coupling and the motor according to different types of couplings: when the quality of the hammer pieces is uneven, each group of hammer pieces must be re selected to make the symmetrical hammer pieces, so that the error of the symmetrical hammer pieces is less than 5G.
(4) The original balance has been disrupted. After the motor is repaired, a dynamic balance test must be conducted to ensure the overall balance.
(5) The foundation bolts of the crusher system are loose or the foundation is not firm. During installation or maintenance, the foundation bolts should be evenly tightened. A shock absorber should be installed between the foundation and the crusher to reduce vibration.
(6) There are hard debris in the broken or crushed hammer chamber. All of these can cause imbalance in rotor rotation and cause vibration of the entire machine. Therefore, regular inspections should be carried out for severely worn hammers. When replacing, it is necessary to replace symmetrically; Any abnormal sound during the operation of the crusher should be immediately stopped for inspection, and the cause should be identified and promptly addressed.
(7) The connection between the pulverizer system and other equipment does not match. For example, improper connection of feed pipes, discharge pipes, etc. can cause vibration and noise. Therefore, it is not advisable to use hard connections for these connecting parts, and it is best to use soft connections.
2. Overheating bearings are important accessories on crushers, and their performance directly affects the normal operation and production efficiency of the equipment. During the operation of the equipment, users should pay special attention to the temperature rise of the bearings and the noise in the bearing parts, and handle any abnormalities as soon as possible.
(1) The unevenness of the two bearing seats, or the misalignment between the motor rotor and the crusher rotor, can cause the shaft to withstand the impact of additional loads, resulting in overheating of the bearings. If this situation occurs, it is necessary to immediately shut down the machine to eliminate the fault, in order to avoid early bearing damage.
(2) Excessive, insufficient or aged lubricating oil in bearings is also the main cause of bearing overheating and damage. Therefore, it is necessary to add lubricating oil in a timely and quantitative manner according to the requirements of the user manual. Generally, lubrication accounts for 70% -80% of the bearing space, and excessive or insufficient lubrication is not conducive to bearing lubrication and heat transfer. Bearings extend their service life.
(3) The fit between the bearing cover and the shaft is too tight, and the fit between the bearing and the shaft is too tight or too loose, which can cause the bearing to overheat. Once this problem occurs, there will be a friction sound and obvious oscillation during the operation of the equipment. Stop the machine and remove the bearings. Repair the friction area and reassemble as required.
3. Crusher blockage is one of the common faults in the use of shredders. There may be problems in the design of the equipment, but it is mostly caused by improper use and operation.
Jul 09, 2023
Leave a message
Crusher Fault Handling
Send Inquiry





