Chinese medicine pill making machine can produce honey pill, concentrated pill, water pill, water pill including pill food. It is suitable for small pharmaceutical factory, large and medium-sized pharmaceutical factory trial production room, Chinese medicine research institute, hospital, private clinic, Chinese medicine pharmacy, precious tonics on-site processing and sales point, the whole machine is made of stainless steel, in line with GMP standards. And small size, low energy consumption, high efficiency, low noise, no pollution, simple operation, safe and reliable, the machine uses 220V lighting, access to electricity is very convenient.
Traditional Chinese medicine pill making machine common failure analysis and countermeasures:
First, wrinkled skin:
After storage for a certain period of time, the honey pill appears wrinkled on its surface, which is called wrinkling or peeling. Often for the following reasons:
1, the packaging is not strict, the honey pill in the hot and humid season moisture absorption, and in the dry season water evaporation, so that the honey pill repeatedly produced expansion and contraction phenomenon caused by;
2. Improper use of lubricant;
3, honey is tender and contains too much water, when the water evaporates after the honey ball atrophy;
Solution: the honey refining to a certain extent, control the water content is appropriate; Strengthen the packaging to make it tight, with wax shell packaging; The lubricant used is suitable and uniform.
Second, the surface is rough:
The surface of the prepared honey balls is rough for the following reasons:
1, the powder is too coarse;
2. Insufficient amount of lubricant.
3, less honey and uneven mixing;
4, the drug contains more fiber;
5, the drug contains too much mineral or shell drugs;
Solution: The general is to crush the powder finer, increase the amount of honey, use older honey, give enough lubricant and other solutions. Can also contain a lot of fiber, mineral medicine and other medicinal taste to be extracted, concentrated into thick paste into honey.
Three, hollow:
When the honey pill is broken apart, there is a small gap in its center, and the common caramel precipitates, which is mainly due to insufficient kneading during pill making.
Solution: The way to overcome this is to strengthen the lump and rub pills.
Four: After the Chinese medicine pill making machine is powered on, the motor does not run
The reason:
1. The switch is in poor contact
2. The power cable is improperly connected or the power plug is loose.
The solution:
1. Repair or replace the switch of the same specifications.
2. Repair the power supply or replace the plug of the same specification;
5. When making pills, the shaft knife rotates or the powder surface sticks to the groove
The discharge stop is loose, and the distance from the bottom of the shaft knife is generated, and the pill cannot be scraped from the groove of the shaft knife.
Solution: Adjust the distance between the discharge plate and the bottom of the shaft groove (about 0.1mm) and tighten the fixing screws.
Six, Chinese medicine pill making machine gear stuck
Solution: Check whether there is debris in the gear groove and clean it.
Seven, when working, the shaft knife has a slight beat
Solution: Loosen the pressing block screw to open the top cover and tighten the 6 hex socket screws evenly.
8. Abnormal noise is generated during the operation of the Chinese medicine pill making machine
1. The friction part of the shaft knife and the body is dry and oil-free;
2, no oil between the gears.
To learn more about our Fangyuan products, please click this link ：https://www.fine-mill.com.
