Before use, check whether the transmission part of the machine is loose and other abnormal phenomena, and the direction of the machine should be consistent with the direction indicated by the arrow. When using, the no-load test should be carried out for 1-2 minutes, and no abnormal phenomenon can be observed before feeding. The material flow should be gradually increased when feeding, and the power consumption and operation of the motor should be observed at any time. After the balance between the feeding and the power supply is running normally, the cutting ram should be fixed and the work should be carried out. If the material is too damp and the bonding is too large, which affects the powder production, the material should be dried or replaced with a thicker sieve plate. Replace the screen plate only by opening the front cover. When installing the front cover, pay attention to the tightness of both handwheels to ensure that the front cover is sealed with the casing. Stop feeding before stopping, and let the machine run for 5-20 minutes before stopping. In order to reduce residual materials.
Small Chinese medicine ultrafine grinder precautions
1, check whether there is foreign matter in the crushing chamber (it must be empty before starting), and turn on the power.
2. Tighten the butterfly nut of the upper cover and crushing cavity.
3, start the motor, turn the empty machine for 1-2 minutes, and then gradually feed the material from the feed tray, feeding should not be too fast.
4, if the material is stuck, the motor does not turn, please close immediately, so as not to burn the motor, after removing the material, continue to use.
5. It is strictly forbidden to open the top cover and reach into the crushing chamber with your hand during use.
6, this machine is a dry crusher, not suitable for crushing wet and greasy.
7. Please replace different screens according to your needs.
8, the machine adopts overheat protector, such as the motor load is too large, will automatically stop, such as continue to operate, please re-press the protector.
9, in the working process of the machine, the current shall not be more than 15 amps.
To learn more about our Fangyuan products, please click this link ：https://www.fine-mill.com.
