Viscous Material horizontal Leaf Mixer Product introduction:
The horizontal ribbon mixer is composed of a U-shaped cylinder, a ribbon mixing blade and a transmission component: the ribbon blade is generally made of double layers, and the outer silver belt collects the material from both sides to the center when working, and the inner ribbon transports the material from the center to both sides to form a convective mixing. Mixing parts can also be made into a leaf type or add a flying knife to adapt to different materials. The cover can be made of arch or fully open, arch can be pressurized, and fully open is convenient to clean the inside of the equipment.
Working principle :WLDH stainless steel horizontal screw belt mixer by the inner and outer diameter screw installed on the mixing shaft to drive the material in the barrel, so that the mixer turns the material in the barrel. Stirrer structure, the helix is designed to be inside and outside, left and right mutual anti-helix, stirrer working inner helix drives the material near the axis to do axis rotation, the shaft is driven from the inside to both sides, the outer helix drives the material near the barrel wall to do axis rotation, the axial is driven from both sides to the inside, resulting in the material in the barrel convection circulation, shear infiltration mixing, to complete the material in a short time of rapid and uniform mixing.
Product features:
1. Drive advantage Standard products adopt gear reducer direct drive, large torque, high reliability, low noise. Large equipment with gear reducer and belt drive, can protect the transmission components in case of unexpected situations. 2. Flexibly disassemble the screw belt spindle and the drive shaft flange, which can be quickly disassembled when the type of mixing shaft needs to be repaired or replaced. The flexible disassembly design enables the U-shaped cylinder to be completely welded with the two ends of the plate, avoiding the accumulation gap caused by the connection of the large flange of the cylinder and reducing the residue.
3. Compared with other types of mixers, the simple cover of the horizontal screw belt is more flexible, can be made fully open, half open, fully closed, fully open for cleaning occasions with high requirements, the use of gas spring support, convenient and safe.
4. The discharge form is generally a pneumatic flap valve, the arc valve is tightly embedded in the cylinder, and the inner wall of the cylinder is flat, no material accumulation and mixing dead Angle phenomenon, reliable edge sealing, to ensure that there is no leakage in frequent switching.
5. Cooling and heating the jacket can be added in the outside of the mixer cylinder, and the cooling or heating of the material can be realized by injecting cold and hot elements into the jacket; Cooling is generally pumped into industrial water, and heating can be channeled into steam or electric heating of thermal oil.
6. The main shaft seal uses a new balanced combination gas seal and packing seal. When mixing ultrafine powder, this sealing form can increase air tightness and effectively block the circulation of gas powder inside and outside the simple.
To learn more about our Fangyuan products, please click this link ：https://www.fine-mill.com.
