What are the maintenance and maintenance points of Chinese medicine ultrafine mill?
Maintenance of Chinese medicine ultrafine grinder:
1, first check the power socket, plug, power cord for oxygen off, broken, if not, you can plug in the power test machine.
2. When the motor is energized and does not rotate, and the wheel plate can be rotated by hand, it can be determined that one of the two starting capacitors of the machine is caused by capacity failure. In this case, it's usually a new one.
3, the other case is that the power does not rotate, the application of external force can rotate, but the motor emits a weak current sound, which is caused by a slight leakage of the starting capacitor. If the current sound is too large, the motor can not start at all, and it is determined that the starting capacitor is caused by short circuit. In the absence of professional instruments, the capacitor can be removed first, the two leads are inserted into the zero and firewire jack of the utility to charge the capacitor, and then the two leads are removed and short-circuit discharge. If the discharge spark can be emitted at this time and there is a very loud "snap" sound, it indicates that the capacitor can be used; If the spark and sound are weak, it indicates that the capacity of the capacitor has decreased, and it is necessary to replace it or add a small capacitor. If the capacitor has been damaged short circuit can not use this method, and must be replaced with the same specification of new products can be repaired.
Chinese medicine ultrafine mill maintenance:
The general quality of this kind of Chinese medicine ultrafine grinder is very good and not easy to damage, and daily maintenance is more important.
1. Check whether the lubrication of the bearing is good.
2. Check whether all fasteners are fastened.
3. Check whether the transmission belt is installed correctly and in good condition. If the belt is damaged, it should be replaced in time. When there is oil on the belt or groove wheel, clean rags should be used to wipe it off in time.
4, check whether the protective device is good, if the protective device is found to be unsafe, it should be eliminated in time.
5, check the damaged cavity for materials or other debris, if sometimes should be removed.
6, check whether the hydraulic jacking machine head or lifting screw is returned, adjust whether the gasket is installed correctly and pressed.
To learn more about our Fangyuan products, please click this link ：https://www.fine-mill.com.
