In order to strengthen the supervision and management of production safety,
Prevent and reduce safety incidents,
Ensure the life of employees
Safety of life and property, the special development of crusher safety operating procedures are as follows:
1, manual turning before operation, to see whether the operation is flexible, there is no blocking.
2, start the mill idling.
1-2 minutes, check for abnormal sounds, pungent smells, lines.
Road, equipment leakage phenomenon, chain, motor bolt is loose, chain tail.
There is no wear or fall off, abnormal should immediately notify the mechanical and electrical maintenance personnel for treatment.
3. Observe whether the discharge particle size is in the specified value after feeding. If it is too large, the raw material moisture should be properly adjusted.
Or lengthen the chain.
4, the feeding stage should stand on the side of the feed port to avoid material or debris spatter, occur.
Security incident.
5, can not be put into the aniseed block, but also can not run with the rod through the material and open the movable door.
6, with load operation should understand whether the motor, bearing temperature is normal.
7, if there is any abnormal situation during operation, should immediately stop and notify mechanical and electrical maintenance personnel for inspection.
The operator can not disassemble the equipment without permission, and it can be put into operation after it is repaired.
8. When cleaning the crystallization of the equipment and repairing the equipment, the power supply should be cut off first.
9, do not belong to this section of the operator is strictly prohibited to start the equipment.
10, shut down, the body can not have more material, the site, equipment clean.
To learn more about our Fangyuan products, please click this link ：https://www.fine-mill.com.
