Mar 01, 2024 Leave a message

Select powder machine several attention issues

At present, many dry powder mixers choose vertical mixers, but experts suggest that horizontal mixers such as: horizontal ribbon mixer, horizontal plow knife mixer, horizontal no-gravity mixer is also a good choice. The equipment has the advantages of high mixing effect, good mixing quality, short discharging time and less residual amount.

1. Fangyuan Machinery selects horizontal mixer according to daily production. The horizontal ribbon mixer is composed of a U-shaped container, a ribbon mixing blade and a transmission component. The U-shaped long cylinder structure ensures the small resistance movement of the mixed material (powder, semi-fluid) in the cylinder body. The positive and negative rotating screw is installed on the same horizontal axis, forming a low power and efficient mixed environment, the spiral blade is generally made of double or three layers, the outer spiral will collect the material from both sides to the center, the inner spiral will transport the material from the center to both sides, which can make the material form more eddy currents in the flow. The mixing speed is accelerated and the mixing uniformity is improved.

 

 

2. According to the working principle of the horizontal screw belt mixer, the ability of the double screw belt used for mixing to push the material in the opposite direction should be basically consistent. The materials of various components enter the mixer after calculation according to the formula proportion, and the materials are mixed under the push of the ribbon spiral blade. The outer screw belt pushes the material from one end to the other section, the inner screw belt makes the material move in the opposite direction, the inner material is pushed to one side after the inside to roll out, the outer material is pushed to the other side after the outside to roll in. In the convection process, the two streams of material penetrate each other, become mixed, and then mix in the rolling process on both sides, so repeated for many times, and finally the boredom after mixing is discharged from the discharge door through the discharge control mechanism.

3. The horizontal mixer should be fed batch by batch after the mixer is started. Do not stop when the mixing is finished, and mix a batch after the discharging is net. If you start again after full load, it will cause the power distance to be too large and burn the motor.

To learn more about our Fangyuan products, please click this link :https://www.fine-mill.com.

Send Inquiry

whatsapp

Phone

VK

Inquiry