Two-dimensional motion mixer is mainly composed of three parts: rotating drum, swinging frame and frame, which uses the "fulcrum" to slide and swing, and is driven by the drive shaft to carry out repeated swinging and rotating composite motion, so as to achieve the interaction of various materials (flow, diffusion, rolling and concentrated liquid mixing) to achieve uniform mixing, widely used in mixing powder and granular materials. It has the characteristics of fast mixing speed, large mixing amount and convenient unloading. The material to be mixed rotates, rotates and mixes with the roll in the roll. At the same time, with the swing of the roller, the mixing movement occurs from left to right and back and forth, under the joint action of these two movements, the material can be obtained in a short time, before using the two-dimensional motion immersion device, the empty running test should be carried out, before the test run, the robustness of all the connected parts of the two-dimensional motion mixer should be checked. Reduce the amount of lubricating oil in the speed reducer and the integrity of the electrical equipment, and then shut down the main engine. Switch, turn on the power, and then run the empty test.
It must not be forgotten that only when there is no abnormal sound, overheated bearing gear and direct temperature rise of the reducer, it can be set into production. If the material on the wall of the two-dimensional motion mixer needs to be improved during operation, please use bamboo and wood tools, do not use hands to avoid hand injury. If you find that the machine vibrates abnormally or makes abnormal sounds, stop the inspection immediately, and the two-dimensional motion mixer should not use too much load. Usually, it is measured by the load of the motor. The heavy-duty current of the 380V motor is normal when mixing, and the normal condition is not more than 6 amps. If the load is exceeded, the mixing capacity should be reduced immediately.
The shaft seals at both ends of the mixing paddle should be kept clean to avoid blackening and material deterioration, the outer gears at both ends of the mixing bucket have square holes, they should be unimpeded to avoid back pressure, its role is to make dirt infiltrate into the shaft and make the material in the push black and metamorphic, managers must be familiar with the technical performance of the two-dimensional movement mixer, internal structure and control structure. During operation, do not leave the workplace to prevent failure and damage to machine parts, and to ensure safe production.
To learn more about our Fangyuan products, please click this link ：https://www.fine-mill.com.
