Crushing principle of the machine hammer type return air high speed crushing. The crushed material can be discharged directly from the grinding chamber, through the discharge port, the general material after grinding to be collected through the cotton bag, the crushed material is collected in the bag, the air is from the small hole of the bag, will not discharge the fine powder, so as not to waste, no pollution effect. The particle size is determined by replacing the screen with different mesh numbers. The machine is equipped with a screen, the screen can be replaced according to customer requirements, when the material is crushed to less than the diameter of the screen hole, the powder comes out of the screen and falls into the aggregate bucket below, the dust flying in the bucket is sucked into the dust bag in the dust removal box through the role of the dust removal motor, and the air is discharged from the fan to the outside.
The machine has simple structure, strong, stable operation, fast and uniform crushing material, and good effect. This machine is made of stainless steel material, all the tooth grooving inside the shell (crushing tank) by precision machining to achieve smooth surface, easy to clean, change the ordinary grinder inner wall rough, easy to accumulate powder, difficult to clean the phenomenon, so that food, medicine, chemical production more in line with national standards, to meet the GMP health requirements.
Dust removal and water-cooled crusher, seasoning Chinese medicine crusher notes:
1, check whether there is foreign matter in the crushing chamber (it must be empty before starting), and turn on the power.
2. Tighten the butterfly nut of the upper cover and crushing cavity.
3, start the motor, turn the empty machine for 1-2 minutes, and then gradually feed the material from the feed tray, feeding should not be too fast.
4, if the material is stuck, the motor does not turn, please close immediately, so as not to burn the motor, after removing the material, continue to use.
5. It is strictly forbidden to open the top cover and reach into the crushing chamber with your hand during use.
6, this machine is a dry crusher, not suitable for crushing wet and greasy.
7. Please replace different screens according to your needs.
8, the machine adopts overheat protector, such as the motor load is too large, will automatically stop, such as continue to operate, please re-press the protector.
9, in the working process of the machine, the current shall not be more than 15 amps.
10, the machine in the external power supply should be equipped with a suitable circuit breaker according to the machine power, the purpose is to automatically cut off the power when the machine load is too large, the current is too large, in order to protect the motor!
11, the machine in the work to ensure that there is a special care.
12, the crushed material particles should not be too large, such as the stuffy machine (that is, the machine due to excessive load causes the speed to significantly slow or passively stop running), should immediately cut off the power supply.
13, if the crushed particles are too large, it should be broken by the crusher, and then crushed with the machine.
To learn more about our Fangyuan products, please click this link ：https://www.fine-mill.com.
