Three-dimensional mixer, commonly known as "multi-direction motion mixer", is a novel material mixer widely used in pharmaceutical, chemical, food, light industry and other industries and scientific research institutions. The machine can mix powder or granular materials with good fluidity very evenly. When the machine is working, due to the multi-direction operation of the mixing barrel, the flow and diffusion of various materials are accelerated during the mixing process, and the specific gravity segregation and accumulation of materials caused by the centrifugal force of the general mixer is avoided, so good mixing effect can be achieved. Three-dimensional mixer cleaning and maintenance standards:
1. Open the weighing door and bin door of the 3D mixer, blow into it with the air pipe, and blow away the dust and accumulated material on the surface.
2. Unplug the gas pipe of the three-dimensional mixer or fold the gas pipe often, to ensure that no gas passes to the mixer. (In the case of the warehouse door is open, so that the accumulated material that will be cleaned can fall down with the trend, and can be ventilated, otherwise the mixing machine will automatically close the warehouse door)3. The fan is fixed in the weighing door to blow inside, the staff of the three-dimensional mixing machine should wear long clothes and the skin should not be naked! Wear a helmet and a mask. We need two people, one in and one out.
4. Enter the 3D mixer, first remove the nozzle with a wrench, clean it with air to be loaded, and then shovel off the material on the warehouse wall and blade. (Shovel homemade, according to the size of the mixer with iron block welded to the iron pipe, sharpen the iron block side on the line
5. The blades can be manually turned to clean up dead corners as needed. Clean it up and then put the nozzle on,
At work, the correct operation of the 3D mixer to ensure the smooth progress of work and the safety of employees,
The reducer of the three-dimensional mixer must be replaced with new oil every three months and used frequently. When replacing, the reducer should be cleaned with new oil.
The inspection parts are worm gear, worm, bearing, oil seal, and the machine parts are checked 1-2 times a month. Whether the operating parts are flexible, whether the fasteners are loose, and if abnormal conditions are found, they should be handled in time.
If the machine is found to vibrate abnormally or make abnormal sounds, during use. Stop the machine immediately for inspection.
The fault should be repaired in time. Electrical control parts should be kept clean and sensitive.
When the mixing slurry is installed and disassembled, it should be lightly disassembled, firmly installed and gently put to avoid deformation and damage.
The residual material of all parts of the 3D mixer should be brushed clean after the end of use. The 3D mixer must be wiped clean, the surface of the machine parts coated with anti-rust oil, and covered with a cloth.
To learn more about our Fangyuan products, please click this link ：https://www.fine-mill.com.
