A. Basic operations
1, Before use, ensure that there is no debris in the crushing room.
2, Put the hopper on the crushing chamber, and then put the feed hopper on the hopper, and fix it with locking bolts.
3. The cloth bag is set on the air outlet, and the cloth bag mouth is tightly clamped.
4, In the case of making sure that everything is ready, turn on the power.
5, The material evenly into the feed port, and pay attention to the ammeter indicator should not be greater than 10A, so as to avoid the current is too large motor speed reduction affect the crushing effect.
6, After the end of feeding, please wait two minutes for the material to be completely crushed, turn off the power, until the motor is completely stopped.
7. Turn off the power and pull out the power socket.
8. Clean the bag nei and hopper after opening the top cover.
B, Blade use
1. When replacing or installing a blade, pay attention to the blade direction.
2. Insert the Phillips screwdriver into the Phillips screw hole in the crushing chamber, and turn the locking nut in the counterclockwise direction with the glove to loosen the nut and replace the blade.
C, Problems encountered in the crushing process, improve the way
1. Grinding requires drying of materials, especially sticky materials. Crush *. The volume should not be too large less than 10 mm to prevent card crushing chamber.
2, Pearls and other requirements of finer, please brush the net. When there is a particle phenomenon in the powder, adjust it with the regulator to achieve the purpose.
3. Please note that the drug in the hopper should not be too much when crushing, and too much should be crushed first.
4, During the working process, please beat the cloth bag normally, to ensure that the air is smooth, if the air is not smooth, resulting in the crusher crushing room temperature is too high. Damaged machine components.
5, When crushed, too much drug into, the protector jumps out, the motor stops running, indicating that the load is too large and improper use, turn off the power and rest for 10 minutes.
6. Press the protector and restart the motor.
7, After the machine is used, please be sure to pull out the power socket, so as to avoid collision with the switch resulting in danger.
To learn more about our Fangyuan products, please click this link ：https://www.fine-mill.com.
