First, the use of high-speed crusher:
Before using the machine, disconnect the power supply, put the crushed sample into the crushing room, cover and lock it, plug in the power supply, turn on the timer switch to time, that is, start to crush, when the rolling sound is more uniform, indicating that the sample has been crushed into powder, you can shut down, disconnect the power supply before taking the sample, open the cover and take out the sample.
Second, the use of high-speed crusher precautions:
1, a crushing sample should not exceed the rated working capacity of grams, so as not to damage the motor due to excessive load, continuous work should be controlled within 3 minutes, intermittent 10 minutes, and then continue to use, to prevent bearing overheating damage to the motor.
2, wet with water fresh soft toughness is very strong, can not be crushed (such as: fresh meat, fruit, etc.).
3, high hardness materials, large soft, need to be sliced or made into small pieces (such as: large Notoginseng, pearls, etc.).
4, oily large such as peanuts, sesame, walnuts, etc., try to dry or fry dry until completely cool before crushing, crushing a small amount of short time more than a few times, generally play 15 seconds, stop 10 seconds, and then play 15 seconds if not fine enough, you can play a longer time, so the operation of the powder effect is ideal.
5, the amount of crushing needs to be determined according to the volume and quality of the material, the mass heavy volume is small, can not exceed the rated number of grams of the crusher bin, large volume, light weight of the material, can not exceed two-thirds of the crushing bin.
6, it is recommended that the crushing amount cover the cutter head or one third of the machine bin is the best, and the minimum crushing amount needs to be not over the blade.
7, the motor does not turn how to do: After long-term use, the carbon brush such as serious wear, the motor does not turn the need to replace the new carbon brush (household is generally about 3 years).
8, in order to ensure safety, the working power supply must have good grounding measures to avoid accidents.
9. When the upper cover is opened, do not power on (connect the ionizing hand, the power can be opened).
10, after long-term use, carbon brushes and blades such as serious wear, need to be replaced.
11. Before each crushing, first check whether the tool head fixing screw is loose and whether the tool head rotates normally.
12, do not use water to clean the crushing bin.
13, the mill motor is a brush motor, boot spark or carbon brush smell out, is a normal phenomenon.
To learn more about our Fangyuan products, please click this link ：https://www.fine-mill.com.
